GAUNTLET TO JAMMA INSTRUCTIONS: ------------------------------ **PLAYER CONTROLS** These are along the end of the board and are designated PPL1 (player 1) through PPL4 (player 4). Each of these takes a female 10 position molex housing & terminals. They are 11 pin connectors on the board but the 11th pin is not necessary for JAMMA. Connect PPL1 and PPL2 to the appropriate JAMMA player 1 and 2 connections. Connect PPL3 and PPL4 directly to the player 3 and 4 joysticks and buttons. --------------- PIN 1 GROUND PIN 2 KEY PIN 3 START PIN 4 FIRE PIN 5 (empty) PIN 6 (empty) PIN 7 RIGHT PIN 8 LEFT PIN 9 DOWN PIN 10 UP PIN 11 NC --------------- **COIN SWITCHES** These are on a connector labeled PCOIN. Use a 6 position .100 female molex for this one. If you have 4 coin slots on your machine, connect these to the appropriate switches, 1&2 through JAMMA and 3&4 directly. In my JAMMA cab I installed 4 coin buttons at the top of the control panel. This way when a player is low on health, he just hits the button instead of digging for the coin switch in the middle of a game. --------------- PIN 1 GROUND PIN 2 KEY PIN 3 COIN 4 (RIGHT) PIN 4 COIN 3 (MIDRIGHT) PIN 5 COIN 2 (MIDLEFT) PIN 6 COIN 1 (LEFT) --------------- **POWER** Tis is the large white 12 position plug layed out like this: +--------+ |1 4 7 10| |2 5 8 11| |3 6 9 12| +--------+ Connect these to JAMMA as indicated below: --------------- 1 GROUND JAMMA GND 2 +SENSE JAMMA +5v 3 EMPTY 4 EMPTY 5 -SENSE JAMMA GND 6 -15V DC JAMMA -5v 7 EMPTY 8 GROUND JAMMA GND 9 +15V DC JAMMA +12v 10 +5V JAMMA +5v 11 +5V JAMMA +5v 12 GROUND JAMMA GND --------------- **PST CONNECTOR** Some of these go to your JAMMA connector, and some go to the Amp board, as indicated: --------------- 1 EMPTY 2 SELF TEST JAMMA Test 3 KEY 4 AUDIO LEFT Amp Audio #2 5 GROUND 6 AUDIO RIGHT Amp Audio #1 7 GROUND 8 COIN COUNTER 1 NC 9 COIN COUNTER 2 NC 10-11 EMPTY --------------- **PVID** This is just video to the RGB, GND and Sync on JAMMA. You only need to connect one of the grounds. --------------- 1 RED JAMMA Red 2 GROUND 3 KEY 4 GREEN JAMMA Green 5 GROUND 6 BLUE JAMMA Blue 7 GROUND 8 GROUND 9 COMPOSITE SYNC JAMMA Sync 10 VERTICAL SYNC 11 HORIZONTAL SYNC --------------- The following connections are all on the Audio Amp board: **JAUX** --------------- This is mostly the audio input from the main board: JAUX 1 KEY? (or empty) NC JAUX 2 JCC1 (coin counter 1) NC JAUX 3 JCC2 (coin counter 2) NC JAUX 4 GROUND JAMMA GND JAUX 5 AUDIO-2 From PST #4 JAUX 6 KEY JAUX 7 SELF-TEST NC JAUX 8 GROUND JAMMA GND JAUX 9 AUDIO-1 From PST #6 --------------- **JSPK** This is the speaker output: --------------- JSPK 1 SPKR2 Directly to Speaker #2 (+) JSPK 2 GROUND Directly to Speaker #2 (-) JSPK 3 BLANK JSPK 4 KEY JSPK 5 SPKR1 JAMMA SPK (+) JSPK 6 GROUND JAMMA SPK (-) --------------- **J15V** This is the sound power supply: --------------- J15V 1 -15V JAMMA -5v J15V 2 -15V NC J15V 3 +15V JAMMA +12V J15V 4 +15V NC J15V 5 GROUND JAMMA GND J15V 6 GROUND JAMMA GND J15V 7 KEY J15V 8 12V AC LO NC J15V 9 12V AC HI NC --------------- OTHER HELPFUL INFORMATION: ---------------------------------------------- JAMMA PINOUTS COMPONENT SIDE SOLDER SIDE _______ Gnd |1 | A| Gnd Gnd |2 | B| Gnd +5vdc |3 | C| +5vdc +5vdc |4 | D| +5vdc -5vdc |5 | E| -5vdc +12vdc |6 | F| +12vdc key |7 | H| key Coin counter 1 |8 | J| Coin Counter 2 |9 | K| Speaker + |10| L| Gnd (speaker) |11| M| Video Red |12| N| Video Green Video Blue |13| P| Video Sync Gnd (Video) |14| R| Service Switch |15| S| Coin Sw. 1 |16| T| Coin Sw. 2 Start 1 |17| U| Start 2 1P Up |18| V| 2P Up 1P Down |19| W| 2P Down 1P Left |20| X| 2P Left 1P Right |21| Y| 2P Right Push 1 |22| Z| Push 1 Push 2 |23| a| Push 2 Push 3 |24| b| Push 3 Spare 1 |25| c| Spare 1 Spare 2 |26| d| Spare 2 Gnd |27| e| Gnd Gnd |28| f| Gnd ------- ----------------------------------------------------------------- | END | -----------------------------------------------------------------